This guide is based on OpenHab. For more details, please visit OpenHab - Zigbee Bindings.
⚠️Note: ZBDongle-P (TI CC2652P Chip) is currently not supported. For detailed progress, please refer to GitHub.
Preparation #
Before getting started, ensure that Zigbee2MQTT is installed and that the ZBDongle is connected to the host's USB port.
If OpenHab have not been installed yet, please refer to the OpenHab installation guide for setup instructions.
Step 1: Install Zigbee Binding #
Go to the Add-on Store, search for Zigbee, and install the openHAB ZigBee Binding.

Step 2: Add Things #
Go to the Things page, click the "Add" icon, and select Ember Coordinator. Then configure the following parameters:
Port: Select the usb-Itead-Sonoff-Zigbee-3.0-USB-Dongle-V2 device
Flow Control: Select None
Keep other settings as default. After configuration, click "Create Things".
Once the Thing's status turns green (ONLINE), the setup is complete.
Add Things

Configuration


Step 3: Add a Zigbee Sub-device #
Put your Zigbee device into pairing mode. Then, click the "Add" button at the bottom right of the Things page, select Zigbee Binding, and click "SCAN" to start scanning and adding Zigbee devices.

Once added, the device can be configured as a Switch and controlled.