This guide is based on IoBroker. For more details, please visit IoBroker - Zigbee.
Preparation #
Before getting started, make sure that IoBroker is installed and that the ZBDongle is plugged into the host's USB port.
If IoBroker has not yet been installed, please refer to the IoBroker installation guide for setup instructions.
Step 1: Add Adapter #
After logging into IoBroker, go to Adapters, search for zigbee, and install the first Zigbee adapter listed.

Step 2: Configure the Adapter #
Go to Instances, open the settings for the Zigbee adapter, and configure the serial port path and device type:
For ZBDongle-E、Dongle-PMG24、Dongle-LMG21
COM port name: /dev/ttyUSB0 //configure according to the actual serial path
Type: SL-EFR32(EMBER) FW 7.4.x.x JSONFor ZBDongle-P(SONOFF Zigbee 3.0 USB Dongle Plus)
COM port name: /dev/ttyUSB0 //configure according to the actual serial path
Type: TIZ-Stack/CCxxox JSONAfter completing the configuration, click "Save".
Wait until the status icon turns green — this indicates that the configuration is complete.

Step 3: Add a Zigbee Sub-device #
Put your Zigbee device into pairing mode.
Then, go to the Zigbee page and click the "Pairing" icon to start searching for and automatically adding Zigbee devices.
